Smart card, Removing the smart card, Replacing the smart card – Dell Latitude E4300 (Late 2008) User Manual
Page 23
Back to Contents Page
Smart Card
Dell™ Latitude™ E4300 Service Manual
Removing the Smart Card
1.
Complete the steps in
What You Need to Know For Your Safety
.
2.
Remove the hard drive (see
Removing the Hard Drive
).
3.
Remove the display assembly (see
Removing the Display Assembly
).
4.
Remove the keyboard (see
Removing the Keyboard
).
5.
Remove the palm rest assembly (
Removing the Palm Rest
).
6.
Remove the four M2 x 3-mm screws that secure the card to the computer base.
7.
Disconnect the card cable from the system board.
8.
Lift the card from the system board.
Replacing the Smart Card
1.
Reseat the smart card.
2.
Replace the four M2 x 3-mm screws to secure the card to the computer base.
3.
Reconnect the card cable to the system board.
4.
Replace the palm rest assembly (
Replacing the Palm Rest
).
5.
Replace the keyboard (see
Replacing the Keyboard
).
6.
Replace the display assembly (see
Replacing the Display Assembly
).
CAUTION:
Before working inside the computer, read the safety information that shipped with the computer. For additional safety best practices
information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1 smart card cable 2 M2 x 3-mm screw (4)
3 smart card
NOTE:
This procedure assumes that you have completed the removal procedure first.