Configuring alert notifications, Configuring e-mail alerts – Dell POWERVAULT MD3620I User Manual

Page 79

Configuration: About Your Storage Array

Configuring Alert Notifications

MDSM can send an alert for any condition on the storage array that requires

your attention. Alerts can be sent as e-mail messages or as Simple Network

Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single

storage array.
To configure alert notifications for all storage arrays:

1 In the EMW, select the Setup tab.
2 Select Configure Alerts.

The

Configure Alerts dialog is displayed.

3 Select All storage arrays.
4 Click OK.

The

Configure Alerts dialog is displayed. To configure e-mail alerts, see

To configure alert notifications for a single storage array:

1 In the EMW, select the Devices tab.
2 Select the relevant storage array, then select EditConfigure Alerts.

The

Configure Alerts dialog is displayed. To configure e-mail alerts, see

Configuring E-mail Alerts

For more information on configuring alert notifications, see "Configuring

1 Open the Configure Alerts dialog by performing one of these actions:

• In the tree view or the table view on the Devices tab in the EMW,

select a node, and then select

Edit Configure Alerts. Go to step 3.

• In the

Setup tab in the EMW, select Configure Alerts. Go to step 2.

2 Select one of the following radio buttons to specify an alert level:

book.book Page 79 Tuesday, June 18, 2013 3:09 PM

This manual is related to the following products: