Dell UPS 1000T - Manual (Page 92)

ULNM with Microsoft Hyper-V or Hyper-V Server 92
• Windows 7 x86/x64 (except Home edit ions; only on Hyper-V Server R2)
• SUSE Linux Enterprise Server 10 SP2 & 11
• Red Hat Enterprise Linux 5.2/5.3/5.4 x86/x64
• Dell ULNM for Windows
NOTE: Hyper-V Server does not support an RS-232 communication port. Connect the UPS through the USB link or
through the Network link (optional H910P Dell Network Management Card).
Hyper-V Manager/Hyper-V Server R1 and R2 Configuration Prerequisites
For the automatic OS boot on start-up following a shutdown event, you must configure the physical
machine to allow automatic OS boot on start-up. This is found in the machine's BIOS. For further
information, see specific documentation of the physical hardware.
NOTE:
It may be required to activate Virtualization Technology Enabled (in the machine's BIOS) to run Hyper-V, in
CPU Information > Virtualization Technology > Enabled.
Guest Component Service Installation
It is necessary to install the additional the Microsoft Guest Component Service to allow Hyper-V to
execute graceful VM shutdown.
To install the Microsoft Guest Component Service:
1 Open the Hyper-V console and start your VM.
2 Select the Action tab and insert the disk integration services.
3 Install the Service. To check that installation was successful, verify that the software is available by
locating it in Control Panel > Add / Remove Programs of the VM.
Services Configuration
To configure services:
1 Open the Hyper-V console and select the VM where the service was installed.
2 Right-click and choose Settings > Integration Services.
3 Check the Operating system shutdown check box (see Figure 73).
0120_3-Dell ULNM UG.book Page 92 Saturday, November 2, 2013 5:34 PM