Acronis Snap Deploy 4 - User Guide User Manual

Page 32

1. Make sure that the CD or DVD drive has a higher boot priority than the hard disk drive. You may

need to open the BIOS setup utility of the machine and adjust the boot priority setting, similarly

to what is shown in the following picture.

2. Attach the USB hard disk drive to the machine.

Tip. Alternatively, you will be able to save the image to a network folder, as described later in

this procedure.

3. Boot the machine from the bootable media you created.
4. On the boot menu, click Acronis Snap Deploy 4 Master Image Creator.

5. In the pop-up window, click Cancel or wait until that window closes.