Acronis Snap Deploy 4 - User Guide - Manual (Page 130)

130 Copyright © Acronis International GmbH, 2002-2012
12 Individual deployment settings
By using individual settings for a machine, you can override one or more deployment settings (p. 85)
of a deployment template.
Example. You created a deployment template to perform deployment to 100 machines. For one of
those machines, however, you need to perform deployment to a different hard disk than the one
prescribed by the template. You override the Target disk layout (p. 86) setting for that machine.
By default, all templates recognize individual settings. You can set up a particular template to ignore
any individual settings (p. 88).
12.1 Enabling, disabling, and resetting individual settings
To enable an individual setting for a machine
1. In the Machines view, click the machine for which you want to set up individual settings.
2. On the Individual settings tab, click Configure.
3. Click the setting that you want to override.
4. Select the Enable this setting to override the common deployment setting check box.
5. Specify the individual setting.
To disable an individual setting for a machine
1. In the Machines view, click the machine for which you want to disable an individual setting.
2. On the Individual settings tab, click the setting that you want to disable.
3. Clear the Enable this setting to override the common deployment setting check box.
Tip: The value that you specified for the individual setting is still remembered, so you can easily re-enable
the setting by reselecting the check box.
To reset individual settings for a machine
1. In the Machines view, click the machine for which you want to reset individual settings.
2. On the Individual settings tab, click Reset.
As a result, all individual settings are disabled, and all values are returned to the preset settings.
The preset settings are the same as for the default deployment settings (p. 99).
12.2 List of individual settings
The following are the individual settings that you can specify. The description of these settings is
similar to that of the common deployment settings (p. 85), with the differences described in this
section.
 Target disk layout (p. 86)
 Disk space utilization (p. 87)
 Machine name and membership (p. 88)
Specify the machine name in Machine name. Because this is an individual name, use of name
patterns is not available.
 TCP/IP properties (p. 90)