Baseline Systems BaseStation 6000 - Manual (Page 80)

BaseStation 6000 Site Controller Manual
72 | P a g e
7 –MANUAL OPERATIONS
Manually Running Zones
The BaseStation 6000 provides the following options for manually running zones.
To water all zones again
This option waters all zones on the selected Remote Base Unit according to the active program.
1. On the Main Page of the BaseStation 6000 software, click the Information tab to activate the Main Menu.
2. On the Main Menu, click Manual, and then click Water All Zones Again. The Adjust Zone tab shows the watering progress.
To water a single zone again
This option waters a selected zone according to the time specified in its active program.
1. On the Main Page of the BaseStation 6000 software, click the Adjust Zone tab.
2. Find the zone that you want to water again, and then click the Actions button on the line for that zone.
3. Click WaterZoneAgain on the Actions menu.
To manually test one zone
This option enables you to test a zone for the number of minutes that you specify.
Note: Only use this option to test a zone for one or two minutes. If you want to manually run a zone for a longer time, use the
Manual Run Zones option (To manually run a list of zones).
1. On the Main Page of the BaseStation 6000 software, click the Information tab to activate the Main Menu.
2. On the Main Menu, click Manual, and then click Test One Zone. The Manually
Operate ONE Zone dialog box opens.
3. In the Starting Zone (1) field, click the up arrow or down arrow so that the zone
that you want to run is visible in the field.
Note: If Zone 1 is displayed in the Starting Zone field, click the up arrowat the
end of the field to scroll through the list of zones.
4. In the On Time In Minutes (2) field, type the number of minutes that you want
the zone to run.
5. When you are ready to begin the manual run, click Start (6) . If necessary, you can click Pause or Cancel to stop the manual
run. The Manually Operate ONE Zone dialog box stays open and shows the time for the zone test counting down. When the
test is done, the Manually Operate ONE Zone dialog box closes.