System adjustments – reference guide, Adjustments that affect the entire system, Adjustments made per remote base unit – Baseline Systems BaseStation 6000 User Manual
Page 120

BaseStation 6000 Site Controller Manual
112 |
P a g e
System Adjustments – Reference Guide
The Baseline 6000 system is capable of many different watering strategies. This section describes in detail the different options
available. It is highly recommended that operators read through this section before setting up any watering strategies. An
understanding of the different ways the system can be set up will be beneficial when deciding on setting site parameters.
There are many features built in to aid in management of the system, from automatic to user defined adjustments. The
following list can be used as a quick reference to determine the best method to accomplish different tasks.
Tip: “Utilities,” “Manual,” “File,” “Maps” and “Window” refer to the options on the Main Menu on the Main Page. “Programs”
button is located in the lower left corner of the Main Page.
Adjustments that Affect the Entire System
Adjustment
How to Access in the Software
More
Information
Set the number of valves the system
can activate
Base Unit tab > Total Active Zones check box
page 11
Enable system adjustment of
watering based upon day intervals
or percentages
Seasonal Adjust menu > Adjust
page 47
Set flow limits that will shut down
system if exceeded
Flow menu > Configure Flow Sensors
page 20
Shut down the system for a set
amount of time if the rain switch is
activated
Rain/Pause menu > Configure > Pause/Rain – This Base
tab
page 18
Shut the system down for a set
amount of time
Utilities menu > Rain shutdown
page 49
Shut the system down for an
indefinite amount of time
Utilities menu > Seasonal Shutdown
page 48
Enter a weather adjustment factor
Adjust Zone tab > Weather Adjust Factor field
page 41
Add a Remote Base Unit
Base Unit tab
page 11
Backup and System Restore
File menu > System Backup / System Restore
Page 111
Adjustments Made Per Remote Base Unit
Adjustment
How to Access in the Software
More
Information
Configuring biCoders
Config Zone tab
page 15
Configuring biSensors
Config Sensor tab
page 21
Number of Active Zones
Base Unit tab > Base & Device fields
page 11
Site Map
Maps menu > Site Map
page 78