Baseline Systems BL-PFS200 Flow Sensor User Manual
Two-wire ready flow sensor installation
BL-PFS100, BL-PFS150, & BL-PFS200
Two-Wire Ready Flow Sensor Installation
1-866-294-5847
Rev 03262013
www.baselinesystems.com
Baseline’s BL-PFS100, BL-PFS150, and BL-PFS300 are PVC tee-type, impeller flow sensors that
provide accurate digital output signals proportional to the velocity of the liquid flowing
through the pipe.
Installation Overview
1. Choose the proper location and
orientation.
2. Install the sensor in the pipe.
3. Make the electrical connections.
4. Program the controller.
Operation Notes
Make sure the flow sensor is assembled and the retaining nut is tightened (hand tight)
before pressurizing the system.
Fill the pipeline and eliminate all trapped air.
The flow sensor should begin transmitting flow immediately; however, it may take up to
a minute for the flow readings to display in the appropriate screens on the BaseStation
controllers.
Always wait for flow to stabilize before setting control limits. Stabilization may take
several minutes in large piping systems.