Wheatheart Swing Away Flex Auger - Manual (Page 96)

6. M AINTENANCE & S TORAGE W HEATHEART - SA F LEX A UGER
6.3. S TORAGE 71’ - 111’
98 30651 R5
6.3. STORAGE
T O PROTECT AUGER IN STORAGE DURING THE OFF - SEASON :
1. Lower the auger to full down position. For SA 111, there should be slight
tension on the lift cable. (see Operation for instructions on lowering).
2. Lubricate all grease fittings according to the maintenance procedure.
3. Inspect auger for damage and note any repairs required. Order replacement
parts from your dealer.
4. Check tire pressure and inflate if necessary. See sidewall for recommended
pressure.
5. Clean and re-lubricate spline on PTO driveline. Cover PTO driveline with a
plastic bag to protect it from the weather and place it in transport saddle.
6. Tow auger to storage area. Park and chock wheels.
T O PREPARE AUGER FOR USE AFTER STORAGE :
1. Check tire pressure and inflate if necessary. See sidewall for recommended
pressure.
2. Tow auger to work site.
3. Remove cover from spline of PTO driveline and re-lubricate.
4. Check oil level in gearbox and refill if necessary (half full only).
5. Replace any damaged parts and decals.
6. Check and perform general maintenance before using auger.
7. SA 111 only: Before raising auger after storage, make certain cable is in
good condition, replacing it if frayed or damaged. Also make sure cable is
properly seated in roller track and that cable clamps are secure.
Note: Use only genuine Wheatheart replacement parts or equivalent. Replacement
parts such as intake guards, pulley guards, PTO driveline shields, winches and
lift cables Must meet ASAE standards or serious injury may result. Use of
unauthorized parts will void warranty. If in doubt, contact Wheatheart or your
Wheatheart dealer. Do not modify any auger components.
WARNING
Support discharge end of auger before
removing or replacing any parts on the
undercarriage.