E-flite Beechcraft Bonanza 15e ARF - Manual (Page 7)

7 Beechcraft Bonanza 15e ARF Assembly Manual
□□
Step 18
Use your radio to center the rudder and elevator
servos. Insert the pushrods into the outer hole of the
servo arms from below and secure them with snap
keepers.
□
Step 19
Slide a silicone keeper on to the threaded end of
the rudder and elevator pushrods. Install a clevis on
each of the pushrod ends so that it is approximately
centered on the threads.
Tailcone Installation
Parts Required
Fuselage Tailcone
Tools Required
Awl Felt-tipped pen
Manila card stock Thin CA
Low-tack tape Pin vise
1/16-inch drill bit
□
Step 1
Cut three tabs measuring 1 x 3/8-inch from Manila
card stock. Use an awl to make a hole 1/8-inch from
the end and centered along the length of each tab.
□
Step 2
Align the holes in the tabs with the pre-drilled holes
in the tailcone mounting tabs on the fuselage and
secure them to the fuselage with low-tack tape.
□
Step 3
Slide the tailcone in place on the fuselage under the
card stock tabs. Tape it to the fuselage with low-tack
tape so that it cannot move.