E-flite Beechcraft Bonanza 15e ARF - Manual (Page 11)

11 Beechcraft Bonanza 15e ARF Assembly Manual
Optional V-Tail Ruddervator Servo
and Pushrod Installation
Parts Required
Fuselage Micro servos (2)
Clevises (2) Silicone keepers (2)
Snap keepers (2)
16 1/2-inch steel pushrods (2)
Tools Required
Pin vise 1/16-inch drill bit
5/64-inch drill bit Pencil
Sidecutters Pliers
Ruler Thin CA
#1 Phillips screwdriver
□
Step 1
Remove the canopy by pushing it forward from the
rear edge to disengage the magnets, then lifting and
pulling aft.
□□
Step 4
Use sidecutters to remove three of the servo arms,
leaving one long arm on opposite sides of each
servo.
□
Step 5
Insert the non-threaded ends of the pushrods into
their housings from the rear of the fuselage.
□□
Step 2
Install the grommets and bushings in the rudder and
elevator servos. Note that the bushing is installed
from the bottom of the servo.
□□
Step 3
Use a #1 Phillips screwdriver to remove the small
servo arm and install a standard 4-way arm on each
servo.