E-flite Beechcraft Bonanza 15e ARF - Manual (Page 23)

23 Beechcraft Bonanza 15e ARF Assembly Manual
□□
Step 15
Apply a small drop of thin CA to the aileron servo
hatch mounting holes in the wing. Allow the CA to
cure completely without using accelerator.
□□
Step 16
Pass the servo lead through the wing rib into the flap
servo bay. Use a #1 Phillips screwdriver to install the
aileron hatch with four #2 x 3/8-inch wood screws.
□□
Step 17
Use low-tack tape to center the aileron.
□□
Step 18
Slide a silicone keeper on to an aileron pushrod
then thread on a clevis so that it is centered on the
threads. Slide the keeper on to the barrel of the
clevis so that it does not interfere with the next step.
□□
Step 19
Attach the clevis to the outer hole of the aileron
control horn. With the servo centered, use a felt-
tipped pen to mark the servo arm location on the
pushrod.
□□
Step 20
Remove the pushrod from the control horn and use
pliers to make a 90-degree bend at the marked
location. Use sidecutters to trim the bent portion to a
length of 1/4-inch.