E-flite Beechcraft Bonanza 15e ARF - Manual (Page 40)

40 Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 6
Apply threadlock to each of the remaining three
motor mount screws and install them with spacers
using a 3/32-inch hex wrench.
□
Step 7
On the forward right-hand side of the battery
compartment, measure approximately 1/2-inch
behind the front edge and in from the side, and make
a mark with a pencil.
□
Step 8
Use a tapered ream to make a hole of approximately
7/16-inch diameter.
□
Step 9
Cut a 1 1/4-inch long section of adhesive-backed
hook and loop material. Remove the backing from
one of the pieces and adhere it to the underside of
the ESC.
□
Step 10
Stick the second piece of hook and loop material
to the piece on the ESC and remove the backing,
leaving the adhesive exposed.
□
Step 11
Feed the motor wires from the ESC into the hole in
the battery floor then press the ESC into place on
the right side of the battery tray.