E-flite Beechcraft Bonanza 15e ARF - Manual (Page 37)

37 Beechcraft Bonanza 15e ARF Assembly Manual
□□
Step 6
Use a 1.5mm hex wrench to remove the brass
wheel collar from an adjustable axle. Install the axle
flush with the end of the gear leg with a 2.5mm hex
wrench. Check that the axle is aligned parallel with
the body of the retract unit; adjust the flat spots as
necessary so that it is.
□□
Step 7
Once the axle alignment is set, apply threadlock to
each of the setscrews and secure them in place with
a 2.5mm hex wrench.
□□
Step 8
Use a file to make a 1/4-inch long flat spot on the
end of the axle.
□□
Step 9
Use a #1 Phillips screwdriver to remove the wheel
collar from a fixed main landing gear axle. Remove
the 2 1/2-inch wheel.
□□
Step 10
Place the 2 1/2-inch wheel on the adjustable axle
with the lettering on the tire facing away from the
gear leg.
□□
Step 11
Place the brass wheel collar on the axle. Apply a
small amount of threadlock to the setscrew. Use a
1.5mm hex wrench to secure it in place over the flat
spot in the axle.