E-flite Beechcraft Bonanza 15e ARF - Manual (Page 49)

49 Beechcraft Bonanza 15e ARF Assembly Manual
□
Step 2
Place the seatbacks over the mounts with the
headrests angled forward as shown. Use a damp
paper towel to clean any excess glue from around
the seat bases then allow the glue to dry.
Note: You may choose to add pilot figures of your
choice at this time.
□
Step 3
Apply glue to the inside of the rear bulkhead in the
canopy. Set the rear panel in place and allow the
glue to dry.
□
Step 4
Use scissors to trim the instrument panel decal to
size. Remove the protective backing and press it
into place on the forward bulkhead beneath the
windscreen.
□
Step 5
Slide the rear cabin floor piece into place through the
forward opening.
□
Step 6
Bend the forward floor piece and slide it into place in
the front of the canopy.
□
Step 7
With the canopy upright, adjust the floor pieces so
that they are positioned correctly and do not overlap.
Tilt the canopy slightly and apply canopy glue along
one side where the bottom frame meets the floor
pieces. Lay the canopy flat and allow the glue to
dry, then repeat for the opposite side and cross
members.