Metrohm 719 S Titrino - Manual (Page 78)

3.2. Remote control commands
719 S Titrino
74
│ │ ├ .C Continue after "hold" ON, OFF ditto
│ │ ├ .O Conditioning OK ON, OFF ditto
│ │ ├ .N Conditioning not OK ON, OFF ditto
│ │ ├ .Re Request after start ON, OFF ditto
│ │ ├ .Si Silo empty ON, OFF ditto
│ │ ├ .EP Entry in EP list ON, OFF ditto
│ │ ├ .RC Recalculation of results done ON, OFF ditto
│ ├ .I Changing an I/O input ON, OFF ditto
│ ├ .O Changing an I/O output ON, OFF ditto
│
├ .PowerOn RESET (power on) $G 3.2.2.87.
├ .Initialise Set default values $G 3.2.2.88.
│ ├ .Select Selection of branch ActMeth,Config,Silo,Calib
│ Assembly,Setup,All ditto
├ .RamInit Initialization of working mem. $G 3.2.2.89.
├ .InstrNo Device Identification $G 3.2.2.90.
├ .Value Input of device identification 8 ASCII characters ditto