Metrohm 719 S Titrino - Manual (Page 13)

2.4 Tutorial
719 S Titrino
9
2.4 Tutorial
This short operating course teaches you to work quick and efficient with the 719 S Titrino,
by means of the most important applications.
Set up your Titrino and connect the peripheral devices needed, see chapter 5.
2.4.1 Entering data, setting the dialog language
We can thus make a start and first take a look at the fundamentals of the entry of data.
We change the dialog language.
• Switch on the Titrino. It is now in the standby state, it shows you the active mode and method name.
• Press the key , the display shows: This is the title of the group "peripheral units". This group contains various inquiries about peripheral units. • Press again . You see the title of a new group of inquiries. This "auxiliaries" group contains the inquiry for the dialog language.
• Pressing the key takes you to the inquir-ies of the group "auxiliaries". Note the ">" sign. All ti-tles of inquiry groups are prefixed by this sign. This is the first inquiry of the "auxiliaries" group: the selection of the dialog language.
• You select the various dialog languages with the key. Press repeatedly until "español" appears in the display. Note the sign ":". It appears if the values can be se-lected with the key .
• Switch on the Titrino. It is now in the standby state, it
shows you the active mode and method name.
• Press the key , the display shows:
This is the title of the group "peripheral units". This
group contains various inquiries about peripheral
units.
• Press again . You see the title of a new
group of inquiries.
This "auxiliaries" group contains the inquiry for the
dialog language.
• Pressing the key takes you to the inquir-
ies of the group "auxiliaries". Note the ">" sign. All ti-
tles of inquiry groups are prefixed by this sign.
This is the first inquiry of the "auxiliaries" group: the
selection of the dialog language.
• You select the various dialog languages with the
"español" appears in the display.
Note the sign ":". It appears if the values can be se-
lected with the key
• Accept the new "value" with .
The next inquiry "fecha" (date) of the group "ajustes
varios" (auxiliaries) is shown.
You can open this inquiry by pressing
too and go through all the inquiries of this group this
way.
configuration
>peripheral units
configuration
>auxilliaries
>auxilliaries
dialog: english
>auxilliaries
dialog: español
SET pH ********
>ajustes varios
fecha 2002-03-13