Metrohm 719 S Titrino - Manual (Page 74)

3.2. Remote control commands
719 S Titrino
70
&Info
Object Description Input range Reference
& Root
:
├ Info Current data
: ├ .Report Transmission of formatted reports $G 3.2.2.58.
│ ├ .Select Report type configuration, parameters,
│ smpl data, statistics, silo, calib
│ C-fmla, def, user method, full,
│ short, calc, all, ff ditto
│
├ .CalibrationData pH calibration data $G 3.2.2.59.
│ ├ .Inp1 For measuring input 1
│ │ ├ .pHas Asymmetry pH 0...7.00...±20.00 ditto
│ │ ├ .Slope Slope of electrode 0...1.000...±9.999 ditto
│ │ ├ .Temp Calibration temperature -170.0...25.0...500.0 ditto
│ │ ├ .Date Date of calibration read only ditto
│ │ ├ .ElectrodeId Id of the calibrated electrode read only ditto
│ ├ .Inp2 For measuring input 2, as for input 1
│ ├ .Diff For differential input, as for input 1
│
├ .Checksums Checksums $G 3.2.2.60.
│ ├ .ActualMethod Checksum of current method read only ditto
│
├ .DetermData Determination data $G 3.2.2.61.
│ ├ .Write Read/write for several nods ON, OFF
│ ├ .ExV Volume of Exchange/Dosing unit read only/read+write ditto
│
├ .TitrResults Titration results
│ ├ .RS Calculated results
│ │ ├ .1 1 st result
│ │ │ ├ .Value Value read only 3.2.2.62.
│ │ ├ up to 9 results
│ ├ .EP Endpoint
│ │ ├ .1 1 st result
│ │ │ ├ .V Value read only ditto
│ │ │ ├ .Meas Measured value read only ditto
│ │ ├ up to 2 EP's
│ ├ .Var Variables C4X
│ │ ├ .C40 Start measured value read only/read+write ditto
│ │ ├ .C41 Titration end volume read only/read+write
│ │ ├ .C42 Titration time read only/read+write
│ │ ├ .C43 Volume drift in SET read only/read+write
│ │ ├ .C44 Titration temperature read only/read+write
│ │ ├ .C45 Start volume read only/read+write
│ │ ├ .C46 Asymmetry pH read only
│ │ ├ .C47 Slope of electrode read only
│ │ ├ .DTime Time for drift correction read only/read+write
│
├ .StatisticsVal Statistics values
│ ├ .ActN Number of results in chart read only 3.2.2.63.
│ ├ .1 1 st mean
│ │ ├ .Mean Mean read only ditto
│ │ ├ .Std Absolute standard deviation read only ditto
│ │ ├ .RelStd Relative standard deviation read only ditto