Metrohm 820 IC Separation Center - Manual (Page 64)

3 Operation
819 IC Detector / 820 IC Separation Center
56
Damping Electronic damping of the analog output
Selection:
on, off
Damping to reduce disturbing pulsations or a
high noise level. Standard solutions and sam-
ples must both be recorded with damping as
this can influence the peak heights.
Remote lines Startup value for remote line settings 1 … 8.
Selection: 0 , 1
Send current parameters immediately to the
819 IC Detector. Parameters are not stored in
the system file (
*.smt ) as long as the file is not
saved.
Time program
On the Program tab of the 819 IC Detector window a user-defined time
program for the remote output lines of the 819 IC Detector can be en-
tered. This program is started automatically as defined in the Start mode
window (see Section 4.4.3 of the «IC Net» Instructions for Use) either at
the moment the determination is started ( Start with determination ) or at
the moment the sample is injected ( Start with inject ).
The Program tab contains the two following subpages:
Program Main time program with all program steps.
Remote configuration Possibility for creation of user-defined remote
commands.