Fig. 24, Suppressor module connections, Fig. 24 ) – Metrohm 820 IC Separation Center User Manual
Page 52
2 Installation
819 IC Detector / 820 IC Separation Center
44
3 Connect column to suppressor module (Suppressor
connection 1)
•
Cut inlet capillary 64 (marked with "Eluent") of suppressor
module 70 to the required length. Use the 6.2126.080 Capil-
lary cutter available as an option.
•
without column heating
Screw inlet capillary 64 on to the outlet end of separating col-
umn 53 using a 6.2744.010 Compression fitting.
•
with column heating
Connect capillary 52 at the outlet of the separating column
(see Fig. 20) to the inlet capillary 64 using the 6.2744.040
Coupling.
4 Fix column
•
without column heating
Insert one or two column holders 59 (6.2027.030, 6.2027.040
or 6.2027.050) in the mounting rails 58 and fasten separating
column in the column holder.
•
with column heating
Insert column heating according to Fig. 10 into the Separation
Center.
Fig. 24:
Suppressor module connections
64 Suppressor inlet capillary for
eluent
65 Suppressor inlet capillary for
H
2
SO
66 Suppressor outlet capillary
for H
2
SO
67 Suppressor outlet capillary
for H
2
68 Suppressor inlet capillary for
H
2
69 Suppressor outlet capillary
for eluent
Eluent
H
2
O
Detector
Waste
Waste
H
2
SO
4
1
3
2
65
64
69
66
68
67