Diode LED DMX WiFi Wall Mount - Manual (Page 5)

1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
[email protected] www.DiodeLED.com 5 OF 5
DMX WIFI WALL MOUNT ZONE LED CONTROLLER
®
Visit the online product page at www.diodeled.com for additional product specifications & warranty information.
• DMX WIFI WALL MOUNT ZONE LED CONTROLLER Specification Sheet
For full specifications.
• Voltage Drop Charts
Use to specify appropriate wire gauge for installation. Available at the ‘Tools & Resources’ page at www.DiodeLED.com.
Additional Resources
QUESTIONS?
Visit www.DiodeLED.com or contact Customer Support at [email protected]
or 1.877.817.6028 Monday through Friday, 7:00am - 5:00pm PST.
Troubleshooting
For thorough troubleshooting of LED strip light and fixtures, see LED fixture installation guides.
LED fixtures not responding to touch
1. Ensure the blue indicator light is on by pressing ‘Power.’ A red indicator signifies the device is off. The blue indicator light will blink rapidly when
pressing/holding any key on the touch pad.
2. Ensure the appropriate zone number was pressed prior to controlling the DMX decoder/fixture. For example, if you know the fixture is addressed
to zone 1, press ‘1’ prior to controlling.
3. Ensure the individual zone has not been turned off. Long pressing zones 1-4 will turn the specific zone ON/OFF. Additionally, long pressing R, G, B,
W will increase/decrease individual brightness and short pressing will turn R, G, B, W ON/OFF.
4. Ensure the DMX decoder/fixture is addressed properly. For example, address ‘001’ will respond to zone 1 of the controller. See ‘Setting the DMX
Address’ for additional addressing information.
LED fixture responding incorrectly
Ensure all wiring connections are correct. Reversing the Data + and Data - will cause lights to flicker and not respond to controller.
5. Check power connections of all components (drivers, DMX decoders/fixtures, DMX controller).
6. DMX Data connections - See ‘Pinout Connection Guide’ and ‘System Diagram’ for RJ45 hard-wiring connections.
7. DMX decoder PWM output connections – See ‘System Diagram’ for CH 1-4 connections.
IG061814-1.2