Diode LED REIGN Touch Dimmer - Manual

IG051514-1.1
1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
®
[email protected] www.DiodeLED.com 1 OF 3
REIGN™ 12-24V TOUCH DIMMER SWITCH
DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Read all warnings and installation instructions thoroughly.
WARNING
Safety & Warnings
Prior to installation, verify all components are a compatible system. Configure and pre-test your LED system prior to permanent installation to ensure all
components are operating correctly. Install in accordance with the NEC and local regulations.
• Install in accordance with the National Electric Code, and local
regulations.
• This product is intended to be installed and serviced by a qualified,
licensed electrician.
• DO NOT connect directly to high voltage power. Install with a compatible
Class 2 constant voltage LED driver (power supply).
• Only install compatible LED drivers and fixtures. Contact technical
support or visit the product page for compatible products.
• This product is rated for indoor installation and is not protected against
moisture.
• Proper heat dissipation will prolong the working lifespan of this product.
Install in a well-ventilated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, fixture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rating, and type (in-wall rated, wet location rated, etc.).
Inadequate wire installation could overhead wires, and cause a fire.
• Do not modify or disassemble this product beyond instructions or the
warranty will be void.
Installation
WARNING Shock Hazard. May result in serious injury or death.
Turn OFF High Voltage AC Power at the main breaker.
Determine Locations to Install 3 Main Components.
Refer to the ‘System Diagram.’
1
ON OFF
OFF
OFF
ON
ON
OFF
OFF
ON
ON
2
Ensure applicable wire is installed between driver, fixture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rating, and type (in-wall rated, wet location rated, etc.).
3
4
Quick Specs
Input / Output Voltage 12-24VDC Constant Voltage
Ambient Temperature † -40°F ~ 140°F (-40°C ~ 60°C)
Minimum Load See driver specs for min load.
Maximum Load 100W (12V & 24V)
Included Models
REIGN-TD-**
† Do not install product in an environment outside the listed ambient
temperature.
** Indicates color finish.
1) Driver 2) REIGN Dimmer 3) Fixture
Remove Existing Wall Plate and Switch.
V+ (Red)
OUTPUT
V+ (Red)
INPUT
V- (Black)
OUPUT
V- (Black)
INPUT
Cap existing ground wires.
Label will indicate direction
to install dimmer.
Wire REIGN Dimmer Between Driver and Fixture. Only Use
Copper Wiring. DO NOT CONNECT TO HIGH VOLTAGE POWER.
• Attach INPUT of dimmer to driver.
• Attach OUTPUT of dimmer to LED fixture.
See ‘Wiring Connections’ below & ‘System Diagram.’
Wiring Connections
DO NOT CONNECT
TO HIGH VOLTAGE Dry Location Only
12V
DC
24V
DC