Diode LED K-RANGE 24 Wall Mount Controller - Manual

1 of 2
INSTALLATION GUIDE K-RANGE 24™ WALL MOUNT CONTROLLER
IG022614-1.0
Safety & Warnings
Before you begin, read all warnings and installation instructions thoroughly.
Prior to installation, verify all components are a compatible system. Configure and pre-test your LED system prior to permanent installation to ensure all
components are operating correctly. Install in accordance with the NEC and local regulations.
• Install in accordance with the National Electric Code, and local regulations.
• This product is intended to be installed and serviced by a qualified,
licensed electrician.
• Do not connect directly to high voltage 120V~277V power. Install with a
compatible Class 2 constant voltage LED driver (power supply).
• Only install compatible LED drivers and fixtures. Contact technical support
or visit the product page for compatible products.
• This product is rated for indoor installation and is not protected against
moisture.
• Proper heat dissipation will prolong the working lifespan of this product.
Install in a well-ventilated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, fixture, and any controls
in between. When choosing wire, factor in voltage drop, amperage
rating, and type (in-wall rated, wet location rated, etc.). Inadequate wire
installation could overhead wires, and cause a fire.
• Do not modify or disassemble this product beyond instructions or the
warranty will be void.
Input / Output Voltage 12-24VDC constant voltage
Control Type
PWM (Pulse Width Modulation).
Compatible with 2-channel K-RANGE
fixtures. Not compatible with 3-channel
K-RANGE fixtures.
Max Current Load 4A x 2CH
Max Output Power 96W/192W (12V/24V)
Ambient Temperature † -4° ~ 122°F (-20° ~ 50°C)
Environment Indoor / dry location
For full specifications, see the ‘Specification Sheet’ available at the online
product page.
Installation
Quick Specs
† Do not install product in an environment outside the listed ambient
temperature. Ensure adequate airflow and heatsinking is considered
when mounting/installing.
1. Turn OFF 120-277VAC power at circuit breaker.
2. Determine an accessible location to install a 12-24VDC constant voltage driver (driver voltage must match fixture voltage). Do not install more than one
PWM controller can be attached to a single output of the driver.
3. Pull main power cable through switch box.
a) Attach low voltage load to K-RANGE controller.
b) Attach LED driver to K-RANGE controller. See ‘Wiring Connections’ and Mounting.’
4. Wire LED driver to 120-277VAC power.
5. Pop off K-RANGE faceplate with a flathead screwdriver and attach to switch box. See ‘Mounting.’ Do not remove ribbon cable from controller.
6. Ensure all connections are secure and turn ON 120-277VAC power at circuit breaker.
WARNING Shock Hazard. May result in serious injury or death.
Turn off power at circuit breaker before installing this product.
Ensure applicable wire is installed between driver, fixture, and any controls in between. When choosing wire, factor in voltage drop, amperage rating, and
type (in-wall rated, wet location rated, etc.). Inadequate wire installation could overhead wires, and cause a fire.