Diode LED OMNIDRIVE - Manual

1.877.817.6028
www.DiodeLED.com
[email protected] www.DiodeLED.com
INSTALLATION GUIDE
1 OF 4
®
OMNIDRIVE™ ELECTRONIC DIMMABLE DRIVER
IG071014-1.1
Safety & Warnings
• Install in accordance with the National Electric Code, and local
regulations.
• This product is intended to be installed and serviced by a qualified,
licensed electrician.
• Only install compatible LED fixtures & controls. Only use copper wiring.
• Proper heat dissipation will prolong the working lifespan of this product.
Install in a well-ventilated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, fixture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rating, and type (in-wall rated, wet location rated, etc.).
Inadequate wire installation could overheat wires, and cause a fire.
• Do not install if product has any visible damage.
• Do not modify or disassemble this product beyond instructions or the
warranty will be void.
Prior to installation, ensure all components are a compatible system. Configure and pre-test your LED system prior to permanent installation to ensure
all components are operating correctly. Install in accordance with the NEC and local regulations.
WARNING Shock Hazard. May result in serious injury or death.
Installation
1
Turn OFF High Voltage AC Power at the main breaker.
ON OFF
OFF
OFF
ON
ON
OFF
OFF
ON
ON
2 Determine Locations to Install 3 Main Components.
Refer to the ‘System Diagrams.’
L
N
V+
V-
Ensure applicable wire is installed between driver, fixture, and any controls
in between. When choosing wire, factor in voltage drop, amperage rating,
and type (in-wall rated, wet location rated, etc.).
1) Compatible
Control
2) Driver 3) Fixture
3
Attach Lighting Load and Control (min load of 60% labeled
load for dimmable installations). Only use copper wiring.
Refer to ‘Wiring Connections’, ‘System Diagrams’, and dimming
control installation guides. Ensure to install a compatible
dimming control listed on the ‘OMNIDRIVE / Dimming Control
Compatibility List’ available at www.DiodeLED.com.
-22 32 50 68 86 104 140 158
20
40
50
60
80
100
Ambient Temperature (°F)
122
Load (%)
a. When installing in ambient temperatures that may reach over
100°F, refer to the ‘Derating Curve’ to avoid overheating and
damage to the driver.
Mount Driver to Surface. See ‘Wiring Connections’ for mounting
holes. Driver may be mounted in any orientation. Mounting
screws are included with 10W, 20W, and 30W models.
4
DERATING CURVE
Quick Specs
Input Voltage 90~135VAC, 50/60Hz
Output Voltage See driver label
Ambient Temperature † -40°F ~ 140°F (-40°C ~ 60°C)
Minimum Load ≥ 60% (for dimmable installations)
Maximum Load Refer to ‘Derating Curve’
Included Models
Indoor/Dry Location Models Outdoor/Wet Location Models
TD-**V-10W TD-**V-60W
TD-**V-20W TD-**V-80W
TD-**V-30W
TD-**V-45W
† Do not install product in an environment outside the listed ambient
temperature.
** Indicates voltage output (12V or 24V).
Before you begin, read all warnings and installation instructions thoroughly.