beautypg.com

Diode LED TRIANT LED Puck Light User Manual

Triant™ led puck lights

background image

TRIANT™ LED Puck Lights

READ ALL INSTRUCTIONS PRIOR TO INSTALLATION

WARNING!! DO NOT CONNECT THIS

PRODUCT DIRECTLY TO 120V AC POWER!

DO NOT CONNECT IN SERIES

TECHNICAL SPECIFICATIONS

• Diameter: 2.72”

• Cut-out Diameter (for recessing): 2.5”

• Depth: 0.53”

• Input Voltage: 12VDC

• Power Consumption: 3.92W

• IP Rating: IP63 (indoor)

• UL Listed

Remove the outer mounting ring from the Puck Light while

leaving the puck’s power cable inside the ring. Attach the

mounting ring to a clean, dry, flat surface with the mount-

ing screws (included) and screwdriver (not included). Place

the power cable of each Puck Light in the notched opening

at the edge of the mounting ring (Fig 1).

Before mounting, perform a dry assembly and confirm

that all lighting and accessories are compatible, properly

connected, and functional. Never mount or install when

connected to power.

MOUNTING INSTRUCTIONS

Fig. 1

Surface Mounting

Determine the location to mount the Puck Light and drill a

hole with a 2.5” hole saw (not included). Remove the outer

mounting ring from the Puck Light (Fig 2a). The Puck Light

has three spring clips to secure the fixture when recessed.

Firmly press the puck in to place (Fig. 2b).

Once mounting is complete, proceed to attaching wiring

connections. Refer to all inline accessory specifications for

maximum amperage ratings.

Recessed Mounting

Fig. 2b

Fig. 2a

SAFETY & WARNINGS

• Turn power OFF at main breaker before servicing

or installing this product.

• This product is intended to be installed and serviced by a

qualified, licensed electrician.

• Install in accordance with the National Electric Code, and

local regulations.

• Install in a well-ventilated, combustion-free environment.

• Do not disassemble or modify this product beyond the

directions in this guide. Do not cut off the attached DC

plug. Doing so will void your warranty.

• Attached wires are not rated for installation behind

walls and ceilings. DC extension cables, connectors and

other accessories/components are not rated for in-wall

installation unless otherwise noted.

• The LED Puck Light is protected only against ambient

moisture, and is not protected against direct moisture.

Do not expose this puck light to direct moisture or install

in wet locations.