Diode LED DMX 8-Way Splitter - Manual

1.877.817.6028
www.DiodeLED.com
[email protected] www.DiodeLED.com
INSTALLATION GUIDE
1 OF 2
DMX 8-WAY SPLITTER
®
DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Read all warnings and installation instructions thoroughly.
WARNING
Safety & Warnings
• Install in accordance with the National Electric Code, and local
regulations.
• This product is intended to be installed and serviced by a qualified,
licensed electrician.
• DO NOT connect directly to high voltage power. Install with a compatible
Class 2 constant voltage LED driver (power supply).
• Only install compatible LED drivers and fixtures. Contact technical
support or visit the product page for compatible products.
• This product is rated for indoor installation and is not protected against
moisture.
• Proper heat dissipation will prolong the working lifespan of this product.
Install in a well-ventilated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, fixture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rating, and type (in-wall rated, wet location rated, etc.).
Inadequate wire installation could overhead wires, and cause a fire.
• Do not modify or disassemble this product beyond instructions or the
warranty will be void.
Quick Specs
Input Signal DMX512
Input / Output Voltage 12-24VDC Constant Voltage
DMX512 Connection Ports
Input: (1x) Male XLR-3
Output: (8x) Female XLR-3
Ambient Temperature † -4° ~ 104°F (-20° ~ 40°C)
Included Models
DI-1804
† Do not install product in an environment outside the listed ambient
temperature.
Prior to installation, verify all components are a compatible system. Configure and pre-test your LED system prior to permanent installation to ensure all
components are operating correctly. Install in accordance with the NEC and local regulations.
Installation
WARNING Shock Hazard. May result in serious injury or death.
Turn OFF High Voltage AC Power at the main breaker.
1
ON OFF
OFF
OFF
ON
ON
OFF
OFF
ON
ON
Determine Locations to Install 4 Main Components.
2
1) Driver 3) DMX Splitter 2) DMX
Controller
4) Fixture(s)
Determine an accessible location to install a compatible driver between
the main breaker and DMX Splitter. Also, determine locations to install
additional system components such as DMX fixtures, controllers, etc .
Attach Lighting Load and Driver. Only use copper wiring.
Reference ‘Wiring Connections’ located further in guide for
visual. Verify a compatible constant voltage driver is installed.
3
Install Additional Components, Verify Connections, and Turn
Main Power ON at Breaker.
ON OFF
OFF
OFF
ON
ON
OFF
OFF
ON
ON
If system remains unresponsive or is working improperly, turn OFF
main power at breaker and verify all connections. Review the ‘Wiring
Connections’, ‘Troubleshooting’, and DMX installation guides.
4
IG061714-1.1
DO NOT CONNECT
TO HIGH VOLTAGE Dry Location Only
12V
DC
24V
DC