Diode LED INFINILINE - Manual

INSTALLATION GUIDE INFINILINE™ 120V LED STRIP LIGHT
1 of 2
Do not bend LED strip light
on a horizontal plane.
Do not fold or crease
LED strip light.
Do not bend LED strip light to a
diameter less than 1.5 inches.
Do not put excessive pressure on surface of
strip light (e.g. glass/acrylic panes etc.).
1.5 in.
Do not cover strip light with any materials. Do not cut off or modify the strip light or attached
AC cord that provides power to the strip light.
Do not power strip light while
attached to spool or tightly coiled.
IMPORTANT SAFETY INSTRUCTIONS.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
• Install in accordance with the National Electric Code and local regulations.
• This product is intended to be installed and serviced by a qualified,
licensed electrician.
• This product must be powered with a GFCI (Ground Fault Circuit
Interrupter) protected circuit when installed in wet locations or outdoors.
• Do not cover strip light as covering may cause the strip light to overheat,
melt, or ignite.
• Do not operate strip light while attached to plastic spool or tightly coiled.
Excess heat may melt the spool and/or cause damage to the tape.
• Do not puncture, cut, shorten, or splice (hard wire) strip light. Doing so
causes risk of electric shock and will void the ETL certification.
• This product and attached AC chord are not rated for in-wall installation.
Do not route the AC cord or strip light through walls, doors, windows or
any part of a building structure.
• Do not use if there is any damage to the strip light or AC cord insulation.
Inspect periodically.
• Do not submerge strip light in liquids, or use the product in the vicinity of
standing water or other liquids.
• Secure this strip light using only mounting clips provided. Do not secure
with staples, nails, its AC cord, or like means that may damage the
insulation or permanently attach the fixture to a building structure.
• Strip light must be handled with care. Excessive handling, bending, and
pressure may damage the product. Do not subject flexible lighting to
continuous flexing.
• This product has an attached polarized AC plug (one blade wider than the
other) as a feature to reduce the risk of electric shock. This AC plug will
only fit into a polarized electrical receptacle. Do not modify the AC plug in
any way. Contact a qualified, licensed electrician if the AC plug does not
fit in the electrical receptacle.
• Do not exceed 164 ft. series runs (for extendable units).
• This product is not dimmable.
• Do not attempt to fix product in the field.
Input Voltage 110-120VAC~ at 50/60Hz
Ambient Temp † -14 ~ +122°F (-10 ~ +50°C)
Environment Outdoor / wet location / IP44
† Do not install product in an environment outside the listed ambient temperature. Ensure adequate airflow and heatsinking is considered when
mounting/installing.
For full specifications, see the ‘Specification Sheet’ at the online product page.
Quick Specs
Dimmable No.
Field-Cuttable No.
Max Run
See packaging label for run lengths.
This strip light is not rated as field-cuttable.
IG-040214-1.2