Diode LED Wet Location Wall Washer - Manual

1 OF 3
INSTALLATION SHEET
Before you begin, read all warnings and installation instructions thoroughly.
Waterproofing XLR-3 Connections
When installing outdoors or in a wet location, ensure water-resistant end caps
are connected to all wet location 3-pin M14 connections. If attaching XLR-3
DMX adapter cables seal all XLR-3 connections with 1.25” wide heat shrink and
finish waterproof tape (not included). Do not use liquid sealants of any kind.
Use a heat gun with a minimum heating temperature of 212° F (100°C) when
shrinking tube.
Operation Overview
Wall Washers can be operated in two ways:
1) Independently (One or more fixtures): Primary fixture operating independently or commanding additional fixtures.
2) With a DMX Controller: One or more wall washers commanded by a DMX controller.
Safety & Warnings
• Turn power OFF at main breaker before servicing or installing this product.
• This product is intended to be installed and serviced by a qualified, licensed electrician.
• Install in accordance with the National Electric Code, and local regulations.
• Install in a well-ventilated, combustion-free environment.
• Do not disassemble or modify this product. Doing so will void your warranty.
• This fixture is not compatible with any traditional dimming controls. Wall washers can only be controlled/dimmed with the on-board interface or with an external DMX
controller. Please contact customer service for additional information.
• Ensure all adjusting screws on mounting brackets and fixtures are properly secured prior to permanent installation.
• When mounting to walls and ceilings, use applicable lag bolts and consider the strength of these surfaces versus the weight of the fixture.
• When installing outdoors or in a wet location, ensure water-resistant end caps are connected to all exposed wet location 3-pin M14 connections. If attaching XLR-3
adapter cables seal all XLR-3 DMX connections with 1.25” wide heat shrink and finish with waterproof tape (not included). Do not use liquid sealants of any kind.
• This fixture is IP65 rated. Attached wet-location 3-pin M14 connections are IP67 rated.
• It is recommended to power this fixture with a GFCI protected circuit.
• This fixture is only UL Listed for connection with a 120VAC, 15- or 20-ampere branch circuit.
• This fixture is not to be used in or around chlorinated, treated or salt water due to the corrosive and degrading qualities of chlorine, saline, and other chemicals on the
fixture components. Keep at least 16 feet away from pools and spas.
• This fixture is rated for use in an environment where the ambient operating temperature is -4° ~ 104° F (-20° ~ 40° C).
WET LOCATION WALL WASHERS
SPHERE-STAR™ Wall Washer
1/2” mounting holes
SPLASHLIGHT™ Wall Washer
3/8” mounting holes
BROADWAVE™ Wall Washer
3/8” mounting holes
212º F (100º C)
Heat the shrink tube evenly Finish with Waterproof Tape
Step 1. Step 2.
Mounting
Ensure fixture is properly mounted and all adjusting screws are properly secured
prior to permanent installation. All fixtures must be individually powered by 120VAC.