Diode LED Lutron Hi-Lume LTE User Manual
Warning, Required components, Install the ulr listed driver

Need Help? www.lutron.com/hilumeled or call the Lutron LED Center of Excellence at 1.877.346.5338
LTE 2-Wire Forward-Phase
ULR Listed Driver |
Installation
Important Notes:
Please read before installing.
• For installation by a qualified electrician in accordance
with all local and national electrical codes.
• Use copper conductors only.
• For indoor use only.
• Check to see that the driver type and rating are suitable
for the application.
• DO NOT install if product has any visible damage.
• If moisture or condensation is evident, allow the product
to dry completely before installation.
• Operate between 32 °F (0 °C) and 104 °F (40 °C).
• 0% to 90% humidity, non-condensing.
For each system ensure you have:
English
One Compatible Lutron Control
1, 2
Required Components
Install the ULR Listed Driver
When installing the ULR Listed Driver, wire as shown.
1. Remove driver and mounting plate from the rest of the junction box. Do not remove driver from mounting plate.
2. Using leads and ground (bundled in junction box) make power, load, and ground connection with provided wire nuts
(see wiring diagrams).
3. Re-install LED driver and mounting plate to the junction box.
4. Ensure compatible dimmer and load are installed and restore power to circuit.
See reverse side for Compatible Controls.
WARNING
Shock Hazard. May result in serious injury or death.
Turn off power at circuit breaker before installing the unit.
Controls Requiring a Neutral Wire
+
041433
Rev. C
01/2014
LutronR
Neutral
Wire
Control
ULR Listed
Hi-lumeR
A-Series
LED Dimming
Driver
Dimmed Hot (Black)
Hot
Neutral (White)
Neutral
Neutral
Ground
6
Ground
Ground (Green)
6
6
Driver and junction box must be grounded in accordance with local and national electrical codes.
Ground provided by grounding of junction box and by using the green ground wire connection.
1
See list of compatible controls on
reverse side.
2
Please refer to Installation Sheet with
your control for wiring instructions.
Lutron Electronics Co., Inc. | 7200 Suter Road
Coopersburg PA, 18036-1299
+
LTEA4U1UKL-AV120 (12 V)
LTEA4U1UKL-CV240 (24 V)
LTEA4U1UKL-XXXXX
120 V~ 50 / 60 Hz UL
R
Listed Driver
120 V~ 50/60 Hz
+ V
(Red)
From Line / Control
To LED Load
- V
(Black with
white stripe)
Ground
(Green)
Neutral
(White)
Dimmed Hot
(Black)
Ground / Bare
+ LED
- LED
Dimmed Hot
Neutral
4
5 W minimum.
5
Load ratings must match driver output ratings.
3
Driver output range is factory-set.
Different output ratings are available for different loads.
LED Light Engine
At least one ULR Listed Hi-lume
R
A-Series LTE Driver
3
At least one compatible LED Load
(light engine)
4, 5
+ V (Red)
+ LED
- V
(Black with White Stripe)
- LED