beautypg.com

Diode LED DMX Wireless Transmitter/Reciever User Manual

Warning, Safety & warnings, Quick specs

background image

1.877.817.6028

www.DiodeLED.com

[email protected]

www.DiodeLED.com

INSTALLATION GUIDE

1 OF 3

DMX WIRELESS TRANSMITTER / RECEIVER

®

DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!

Read all warnings and installation instructions thoroughly.

WARNING

Safety & Warnings

• Install in accordance with the National Electric Code, and local

regulations.

• This product is intended to be installed and serviced by a qualified,

licensed electrician.

• DO NOT connect directly to high voltage power. Install with a compatible

Class 2 constant voltage LED driver (power supply).

• Only install compatible LED drivers and fixtures. Contact technical

support or visit the product page for compatible products.

• This product is rated for indoor installation and is not protected against

moisture.

• Proper heat dissipation will prolong the working lifespan of this product.

Install in a well-ventilated area free from explosive gases and vapors.

• Ensure applicable wire is installed between driver, fixture, and any

controls in between. When choosing wire, factor in voltage drop,

amperage rating, and type (in-wall rated, wet location rated, etc.).

Inadequate wire installation could overhead wires, and cause a fire.

• Do not modify or disassemble this product beyond instructions or the

warranty will be void.

Quick Specs

Input Voltage

5VDC Constant Voltage

Transmitting Distance

1000 ft. effective open area

Wireless ID’s

7 color-coded ID’s: Red, green,

yellow, blue, pink, cyan, white.

Ambient Temperature †

-4° ~ 104°F (-20° ~ 40°C)

Included Models

DI-0820, DI-0821

† Do not install product in an environment outside the listed ambient

temperature.

Prior to installation, verify all components are a compatible system. Configure and pre-test your LED system prior to permanent installation to ensure

all components are operating correctly. Install in accordance with the NEC and local regulations. Both male or female transmitters may be installed as

a transmitter and/or receiver.

Installation

Power up the master DMX512 fixture. If controlling independently

(no additional DMX controller), set the address to ‘001’. If controlling

with a separate DMX controller, see the controller instruction

manual for addressing information.

1

Attach a single DMX transmitter to the Master fixture. Attach

the adapter to the transmitter and plug the adapter into a

120VAC receptacle.

2

Using a thin screwdriver or stylus, press the recessed button on

the transmitter to cycle to the desired wireless network.

(Red, green, yellow, blue, purple, cyan, or white)

3

Power up the first Slave fixture. Address to ‘002’ if no separate

DMX controller is being installed. Attach a single DMX receiver

and attach the included plug-in adapter. Cycle to the same

wireless network the Master fixture is addressed to.

4

The transmitter on the Master fixture should now be blinking

red, while the receiver attached to the first slave should be

blinking green. If the transmitters are not connecting, perform

a ‘soft reset’ by cycling through all of the programmed modes of

the Master fixture. A data signal may not transmit if the Master

fixture is initially fixed to a static color. Performing a soft reset or

cycling to a dynamic mode will initiate data transmission.

5

Continue adding additional Slave fixtures. Ensure to address

each additional slave fixture with an individual address (e.g.

‘003’, then ‘004’, etc.).

Addressing Slave fixtures to the same ID

will cause signal issues.

See ‘System Diagram’ for illustrations. See the product web page for

additional system designs including a remote DMX controller installation.

6

DO NOT CONNECT

TO HIGH VOLTAGE

Dry Location Only