Brandmotion 2000-3801 - Manual (Page 8)

Section 2: Buick Regal Instructions, 2011 – Current
2000-3801 Instructions 10-10-12.doc Page 8 of 24
17. Set the DPS dip switches for Buick Regal. Flip the first
and fifth switches to the “up” position – “UDDDU”.
(Figure 12)
Figure 12
18. Plug white 4-pin connector into DPS module and wait
10 seconds. (Note: There should be no sound from the
speakers). Disconnect white 4-pin connector from back
of DPS module.
19. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from the
radio. Ensure radio head unit is working properly
including all speaker channels.
If you do not hear any sounds, recheck connections
and repeat Steps 15 through 19.
20. Disconnect vehicle negative battery cable.
21. Remove passenger hush panel by using 7mm socket
driver remove the bolts.
22. Using the supplied 24” wire ties, secure DPS module
under front of console or behind carpet on passenger
side upper foot well.
23. Reassemble vehicle.
24. Reconnect negative battery cable of vehicle.
25. Place Bongiovi DPS Badge on left side of IP center
trim.