Brandmotion 2000-3801 - Manual (Page 23)

Section 7: Chevy Sonic Instructions, 2012 - Current
2000-3801 Instructions 10-10-12.doc Page 23 of 24
9. Connect the female end of the 44-pin connector from
the DPS harness to the back of the radio head unit.
(Figure 6)
Figure 6
10. Connect the two white connectors of the DPS
harness to the DPS module. (Figure 7)
Figure 7
11. Connect the DPS turn-on switch to the remaining
connector on the DPS harness. (Figure 8)
Figure 8
12. Reconnect negative battery cable of vehicle.
13. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm that all of the DPS unit’s
dip switches are set to “down” position – “DDDDD”.
(Figure 9)
Figure 9
14. Turn vehicle ignition key to “ON” position. Turn on
radio head unit for 10 seconds. (Note: There should
be no sound from the speakers). Disconnect white
4-pin connector from back of DPS module. (Figure
10)
Figure 10
15. Set the DPS dip switches for Chevy Sonic. The
second, third, and fourth switches should be flipped
to the “up” position – “DUUUD”. (Figure 11)
Figure 11