Brandmotion 2000-3801 - Manual (Page 17)

Section 5: Chevy Cruze Instructions, 2011 – Current
2000-3801 Instructions 10-10-12.doc Page 17 of 24
20. Connect the female end of the 44-pin connector
from the DPS harness to the back of the radio head
unit. (Figure 12)
Figure 12
21. Connect the two white connectors of the DPS
harness to the DPS module. (Figure 13)
Figure 13
22. Connect the DPS turn-on switch to the remaining
connector on the DPS harness. (Figure 14)
Figure 14
23. Reconnect negative vehicle battery cable.
24. Place DPS module with Bongiovi DPS Acoustics side
face down. Confirm the DPS unit’s dip switches are
set to the “down” position – “DDDDD”. (Figure 15)
Figure 15
25. Turn vehicle ignition key to “ON” position. Turn on
radio head unit for 10 seconds. (Note: There should
be no sound from the speakers). Disconnect white
4-pin connector from back of DPS module. (Figure
16)
Figure 16
26. Set the DPS dip switches for Chevy Cruze. The
second and third switches should be flipped to the
“up” position – “DUUDD”. (Figure 17)
Figure 17