Brandmotion 2000-3801 - Manual (Page 18)

Section 5: Chevy Cruze Instructions, 2011 – Current
2000-3801 Instructions 10-10-12.doc Page 18 of 24
27. Plug white 4-pin connector into DPS module and
wait 10 seconds. (Note: There should be no sound
from the speakers). Disconnect white 4-pin
connector from back of DPS module.
28. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from
the radio. Ensure radio head unit is working
properly including all speaker channels.
29. If you do not hear any sounds, recheck connections
and repeat Steps 24 through 29.
30. Disconnect vehicle negative battery cable.
31. Using a 7mm socket driver, remove the bolts from
the passenger hush panel and remove the panel.
32. Using the supplied 24” wire ties secure the DPS
module under passenger foot well behind HVAC
duct. (Figure 18)
Figure 18
33. Reassemble vehicle.
34. Reconnect negative battery cable.
35. Place Bongiovi DPS Badge on left side of IP center
trim.