Brandmotion 2000-3801 - Manual (Page 21)

Section 6: 2013 Chevy Malibu Instructions
2000-3801 Instructions 10-10-12.doc Page 21 of 24
15. Connect the DPS turn-on switch to the remaining
connector on the DPS harness. (Figure 12)
Figure 12
16. Reconnect negative battery cable.
17. Place DPS module with Bongiovi DPS Acoustics side
face down. Confirm the DPS unit’s dip switches are set
in the “down” position – “DDDDD”. (Figure 13)
Figure 13
18. Turn vehicle ignition key to “ON” position. Turn on
radio head unit for 10 seconds. (Note: There should be
no sound from the speakers). Disconnect white 4-pin
connector from back of DPS module. (Figure 14)
Figure 14
19. Set the DPS dip switches for 2013 Chevy Malibu:
The third and fourth switches should be flipped to the
“up” position – “DDUUD”. (Figure 15)
Figure 15
20. Plug white 4-pin connector into DPS module and
wait 10 seconds. (Note: There should be no sound from
the speakers). Disconnect white 4-pin connector from
back of DPS module.
21. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from the
radio. Ensure radio head unit is working properly
including all speaker channels.
If you do not hear any sounds, recheck connections
and repeat Steps 17 through 21.
22. Disconnect vehicle battery
23. Secure DPS module under front of console bracket
using supplied zip ties or behind upper foot well carpet.
24. Reassemble vehicle
25. Reconnect negative battery cable of vehicle.
26. Place Bongiovi DPS Badge on the faceplate controls
to the left side of CD slot.