Brandmotion 9002-9703 User Manual
Mirror & mirror harness pinout

9703 Instructions 10-7-13.doc
Page 1 of 2
9002-9703 Installation Instructions (Infinity Auto Dimming
Wedge Mount Mirror with HomeLink and Compass)
IMPORTANT
:
Check kit contents and read instructions before installing. For the latest full color instructions please visit
www.brandmotion.com
Kit Contents
Infinity Auto Dimming Mirror with HomeLink & Compass Mirror Harness
Homelink Programming and Information Guide These Instructions
Mirror Mounting
NOTE: This mirror has a Wedge/ D-tab style mounting base; please check our Application Guide to ensure it is compatible with your
vehicle. Additionally, Brandmotion offers windshield mirror adapter brackets, Kit # 5000-VWAB (some Volkswagen vehicles) and Kit
#5000-CAMLOCK (some Honda & Subaru vehicles), available separately.
NOTE 2: In some cases, it may be necessary to remove a cover to access the wedge mount on the windshield and/or modify the
cover slightly to clear the mirror mount. Additionally, if your vehicle is equipped with a mirror cover, mirror adjustability may be
restricted.
To install:
1. Loosen vehicle mirror screw using a T20 Torx driver and
remove existing vehicle mirror.
CAUTION: Do not twist mirror as windshield damage could result.
2. Carefully slide supplied Mirror onto windshield tab.
3. Torque supplied Mirror screw to 1.8 Nm (16 lb-in) and do not
exceed 2.2 Nm (19.5 lb-in).
Mirror Wiring
1. Use a multimeter to test for vehicle Igniton (+) and Reverse
(+) signals. Typical locations are behind the driver or
passenger side kick panel or under the dash. Set parking
brake, start vehicle, and have an assistant shift into Reverse
while you test for Ignition and Reverse signals.
2. Plug Mirror Harness into Mirror and route
beneath headliner and down the A-pillar closest
to the Ignition and Reverse signal locations.
3. Splice Mirror Harness wires to the following
required connections:
Red - Ignition controlled power 12v+ when key is
ON
Black - Chassis ground
Green - Connect to Reverse (+) power. NOTE:
While not a required connection, connecting
Reverse disables the vehicle’s auto dim function
while vehicle is in reverse.
4. If vehicle is equipped with Exterior Auto Dimming
Mirrors, use a multimeter to identify the appropriate
vehicle wires and splice the
Blue wire to Exterior
EC (auto dimming) mirrors (–) and the White
wire to Exterior EC (auto dimming) mirrors (+)
IMPORTANT: If vehicle is NOT equipped with Exterior
Auto Dimming Mirrors, isolate Blue & White wires
and cover with electrical tape.
Mirror & Mirror Harness Pinout
PIN
MIRROR
WIRE
COLOR
MIRROR
HARNESS
WIRE COLOR
FUNCTION
1 - 3
N/A
N/A
Not used
4
Purple
White*
Exterior EC
(auto dimming)
mirror (+)*
5
N/A
N/A
Not used
6
Red
Red
Ignition (+)
7
Orange
Green
Reverse (+)
8
Black
Black
Ground
9
Gray
Blue*
Exterior EC
(auto dimming)
mirror (–)*
10
N/A
N/A
Not used
*If vehicle is equipped. Outside
EC (auto dimming)
Drive is 1.20 - 1.30v DC
These instructions only pertain to functions on the supplied
mirror and do not support other vehicle features.