4 scsi/parallel select - sw2 – Autocue WinCue Pro News Version 1.3 User Manual
Page 149

WinCue Pro News User Guide IMT Card Information
• 149
When a dipswitch is in the top position it is on and when it is in the bottom position it is
off. The dipswitch positions for each SCSI ID is shown in the table below:
14.1.4
SCSI/Parallel Select - SW2
The I.M.T. card can prompt using data sent through either the SCSI port or parallel
port of your PC. By Default it is set up to use SCSI. Dip switches 4 on SW2 controls
whether the SCSI or parallel port is used.
When a dipswitch is in the top position it is on. When it is in the bottom position it is off.
The dipswitch positions for each SCSI ID is shown in the table below: