Autocue WinCue Pro News Version 1.3 - Manual (Page 11)

WinCue Pro News User Guide WinCue Pro News Installation • 11
1.1.1 Before Installing your chosen Operating System
Before you install your chosen operating system you should configure your SCSI card
in accordance with the documentation supplied with it. Do NOT at this stage install
any hardware supplied with WinCue Pro News.
1.1.2 WinCue Pro News Installation Help
There are issues to look out for when installing WinCue Pro News:
WinCue Pro News works on Window's 95, 98, Window's NT 4.0, Window's 2000 and
Window's XP. Windows ME is NOT supported. It is not recommended to have a SCSI
hard disk or any other SCSI device on the same SCSI bus as the IMT Card.
If you have this setup then see the SCSI documentation below.
We recommend using an Adaptec 29xx SCSI adapter in a desktop PC. If you are
using another Adaptec card e.g. 2906xxx Ensure that the SCSI cards ROM BIOS is not
Version 1.3x, if so apply downgrade, which can be obtained from Autocue.
Note: Not all Adaptec SCSI cards can be downgraded.
Use an Adaptec 1460 Slim SCSI adapter in a laptop PC.
For both desktops and laptops do not use a motherboard that uses an Intel TX
chipset. Only use genuine Intel processors. We recommend you don’t use an Intel
Celeron processor.
Ensure that the installed SCSI drivers match those in the following SCSI
documentation.
1.2 The WinCue Pro News Package
The WinCue Pro News package consists of:
• Software (1 CD plus 1 License diskette)
• I.M.T. Scroll Card
• Scroll Control