Rockwell Automation 2755 Enhanced Decoder Series B - Manual (Page 263)

15–75 ASCII Host Commands
Publication 2755-833
DD - Set Configuration to Default Values
Command Format: DD
Function: Sets configuration in operating memory to the
default values.
Important: Host port communication
parameters and the contents of storage memory
are not changed with the DD command.
Parameters: None
Response: = rr
rr = response code
= end of message control code
Example: DD
Command: DD
Response: = 00CRLF
00 = command complete
response code
CRLF = end of message control code
for Carriage Return and
Line Feed.
RD - Set Configuration to Factory Defaults and Restart
Command Format: RD
Function: Resets decoder to factory defaults, saves the
configuration in storage memory, and then
restarts the decoder. Operation then resumes
using the new configuration parameters. Refer to
Appendix B for factory default settings.
Important: Host port communication
parameters are not changed to default values
with this command.
Parameters: None
Response: = 98
98 = Indicates the command was
received and the decoder is
resetting. The reset takes
approximately 5 seconds.
= end of message control code