Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 61)

Chapter 7
Creating Data Display Screens
7–5
When inserting a data display field, you must provide register information
that determines the address and format of the data being displayed. This
section describes options available for data display registers.
Bit
The register information for a Bit display is shown below.
SLC or PLC
depending upon protocol.
Refer to Appendix D
for default bit text.
Format Selection Description
Register Number The controller address from which the bit will be monitored.
Bit Number The Bit number of a multiple bit address which will be monitored for
status if the register number designates a multiple bit address (a 16
bit data address, for example). This selection is irrelevant if the
register number refers to a Bit type address.
Text when Bit is OFF (0) The text description (20 character maximum) to be displayed when
the bit is in an OFF (0) state.
Text when Bit is ON (1) The text description (20 character maximum) to be displayed when
the bit is in an ON (1) state.
Display Register
Format Selections