Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 109)

Chapter 14
Entering DTAM Configuration Data
14–3
The update interval specifies the DTAM display update rate. The Update
Interval is the period of time between read and write requests to the
controller. This is not the rate at which data is read from or written to a
controller.
When you select Update Interval from the DPS Configuration - Option
Selection menu, the following is displayed:
To assign a new update interval, enter a valid number from 0.05 to 12.50
seconds in any increment of 0.05 seconds and press [Return].
To save the new update interval, press [Esc]. You are then returned to the
DPS Configuration - Option Selection menu.
Update Interval