Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 152)

Chapter 19
Transferring / Printing Application Files
19–4
9. Highlight the serial port on your computer that is connected to the
DTAM (COMM 1 or COMM 2) and press [Return].
10. When communication is established, the following screen appears:
☞
If a communication link does not
occur in 10 seconds, you get an
error message. Check DIP switch
settings and cable connections.
11. Enter or select the file name that you want to download. If the
application file type (DH-485, PLC5 DF1, or Remote I/O) is different
from the existing operating system, you are prompted to download the
new operating system.
12. Press [Return] to load the application file.
The download begins and the following screen shows the progress of the
download operation.
13. During the downloading, the DTAM alternately displays:
Programming Mode
Transfer in Progress
Programming Mode
Copying to Memory
Downloading
an Application