Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 41)

Chapter 4
Creating or Editing an Application File
4–5
2. Press [Return] to save the application under the file name entered when
the application file was opened.
Or enter a new file name:
If you were creating a new file, the new file name replaces the file
name entered when the application was opened.
If you are editing an existing file, the original file is unchanged.
The file and all edits made prior to the last save are stored under the
new file name.
3. After saving the file, you can continue with your editing of the application
To save an application before exiting:
1. Exit the software by pressing [F10].
You are prompted save the application under the current file name or you
can enter a new file name.
2. If you enter a new file name, the original file is unchanged. All edits are
stored under the new file name.
After saving the file, you are returned to a DOS prompt.