Rockwell Automation 1798-IB4 FlexArmor User Manual - Manual (Page 39)

Publication 1798-UM001B-EN-P - November 2002
Configure Your DeviceNet Adapter 3-11
The following table describes the parameters in the Advanced
Parameters window.
Parameter # Parameter Name Description
3 Input Size Number of Read words. These are determined by
other Parameter selections and cannot be set by
the user.
5 Output Size Number of Write words. These are determined by
other Parameter selections and cannot be set by
the user.
6 Config. Size Number of Configuration words. These are
determined by other Parameter selections and
cannot be set by the user
10 Program Mode
Behavior Determines the state of the Outputs when the
Controller enters Program mode. The options are:
•
Reset to Zero
•
Hold Outputs in Last State
•
Use Safe State Output Values (Set under
Flex Config. tab.)
11 Communication
Fault Behavior Determines the state of the Outputs when the
Controller enters Program mode. The options are:
•
Reset to Zero
•
Hold Outputs in Last State
•
Use Safe State Output Values (Set under
FLEX Config. tab.)
13 Module Fault Determines the state of the Inputs in the event of a
Module Fault. The options are:
•
Zero Inputs
•
Hold Last Input Values