Rockwell Automation 7763 OneGear MV SMC Flex Solid-State Motor Controller - Manual (Page 36)

34 Rockwell Automation Publication 7760-IN001
B-EN-P - June 2013
Chapter 4 OneGear Standard Plenum
Figure 38 - Front and rear outer side bracket attached
10. Remove the temporarily fastened hardware from Step 4 and 5; the inner
side bracket should stay in place as a result of Step 9.
11. Attach the outer side bracket that is on an angle (81023-075-01) at the
front and rear of the plenum using M8 hardware (M8 HHCS, 19 mm
(0.75”) OD flat washers and lock washers). Refer to
Figure 39 .
Figure 39 - Attach outer side bracket at front and rear
12. Install the inner top bracket (81023-001-54) and outer top bracket
(81023-075-03) using M8 hardware (M8 HHCS, 19 mm (0.75”) OD flat
washers and lock washers), refer to
Figure 40 .