Rockwell Automation 7763 OneGear MV SMC Flex Solid-State Motor Controller - Manual (Page 17)

Rockwell Automation Publication 7760-IN001
B-EN-P - June 2013
15
Equipment Installation Chapter 3
Install Converter Roll-out
Module Pull Handle
At the base of the converter roll-out module, an attachment point for the pull
handle is provided.
The pull handle connects to the module base with a pin ( Figure 10 ).
Each converter roll-out module should be extracted by pulling outwards. The
converter roll-out module should be maintained level and not be tilted at least
until the middle wheels reach the ramp attachment points to the cabinet, as
shown in (
Figure 11 ).
Figure 10 - Insertion of Pull Handle for Roll-out Converter Module
IMPORTANT Do not push or pull on the clear barrier to remove the converter module.
IMPORTANT Check the fiber optic and current loop cables are not being snagged or pinched
when removing or installing the converter module.
Pull Handle
Ramp