Rockwell Automation 7763 OneGear MV SMC Flex Solid-State Motor Controller - Manual (Page 13)

Rockwell Automation Publication 7760-IN001
B-EN-P - June 2013
11
Equipment Installation Chapter 3
The fiber optic cables are individually identified. Fiber optic cables are
disconnected from the circuit by squeezing the latch lever of each fiber optic
terminal and pulling the fiber optic line out of the multi-channel fiber optic
circuit board (
Figure 5 )
Figure 5 - Multi-channel Fiber Optic Circuit Board Location
The cables should be carefully coiled on top of the PowerBricks, so they will not
be damaged when the cart is removed
Reconnection of fiber optic cables requires that the fiber optic cables, for each
phase of converter module, must be connected to the transmitter terminals of the
appropriate phase location on the fiber optic multiplexer circuit board. Within
each phase of fiber optic connectors the order of connection is not critical.
Figure 6 shows a close-up view of the fiber optic multiplexer board and the
grouping of fiber optic connections per phase.
IMPORTANT Note the locations of the fiber optics from the fiber optic circuit board before
disconnecting them.
Multi-channel Fiber
Optic Board location