Rockwell Automation 7763 OneGear MV SMC Flex Solid-State Motor Controller - Manual (Page 10)

8 Rockwell Automation Publication 7760-IN001
B-EN-P - June 2013
Chapter 2 Transportation and Handling
Rod or Pipe Rollers
This method is only suitable when there are no inclines and the controller is
being moved on level floor. Boards 50 x 152 mm (2 x 6”) or equivalent and at
least 300 mm longer than the controller must be placed under the shipping skid,
as shown in
Figure 3 .
Carefully ease the shipping skid over the rollers until the equipment weight is
borne on the rollers. The controller can be rolled to its desired location. Steady
the load to prevent tipping.
Figure 3 - Rod or Pipe Rollers
Fork Lift Truck
A single fork lift truck may be used, extreme caution must be exercised.
1. Insert the forks into openings of the shipping skid from the rear of the
controller.
2. Carefully balance the controller on the forks and apply safety straps.
Shipping Skid Removal
Internal access is not required to remove the wooden shipping skid from the
converter cabinet. External angle brackets attached to the enclosure are used to
attach the enclosure to the wooden skid.
Remove the angle brackets and the associated hardware. When the enclosure is
lifted by overhead means, the wooden skid can be removed.
ATTENTION: Ensure that the load rating of all lifting equipment is sufficient to
safely raise the controller sections. Refer to the packing slip for shipping
weights.
2 x 6 in. minimum (50.8 x 152.4 mm)