Rockwell Automation 2755 Decoded Hand-Held Scanner - Manual (Page 37)

Scanner Configuration (for AdaptaScan Pass Through Cable) 2-3
Publication 2755-6.5
The scanner is now set to these defaults:
Item Default Setting
Code on
Page:
Cable Type AdaptaScan Pass Through Cable 2-2
Symbologies All Enabled 2-4
Transmit UPC-A Check Digit Enabled 2-8
Transmit UPC-E Check Digit Enabled 2-8
Convert UPC-E to UPC-A Disabled 2-8
EAN Zero Extend Disabled 2-9
Decode UPC / EAN Supplemental Disabled 2-9
UPC-A Preamble System Character 2-10
UPC-E Preamble System Character 2-10
UPC Security Level/ EAN 0 2-11
CLSI Editing Disabled 2-12
NOTIS Editing Disabled 2-12
Codabar Decode Redundancy Disabled 2-12
Transmit Code 39 Check Digit Disabled 2-13
Buffer Code 39 Disabled 2-13
Code 39 Full ASCII Disabled 2-13
MSI Plessey Check Digit One 2-14
MSI Plessey 2 Check Digit Algorithm Mod 10 - Mod 10 2-14
Convert Interleaved 2 of 5 (14 digit)
to EAN 13
Disabled 2-15
Interleaved Code Length 14 2-15
Discrete 2 of 5 Code Length 12 2-15
Prefix/Suffix None 2-17
Data Transmission Format Suffix Only 2-19
Transmit No-Read Message Disabled 2-19
Transmit AIM ID Character Disabled 2-20
Transmit Code ID Character Disabled 2-20
Beep After Decode Enabled 2-21
Power Mode Low Power 2-21
Laser On Timeout 3 Seconds 2-22
Hands-Free Stand Operation Timeout 60 minutes 2-24