Rockwell Automation 2755 Decoded Hand-Held Scanner - Manual (Page 14)

Scanner Configuration (for Synapse Cables) 1-3
Publication 2755-6.5
The scanner is now set to these defaults:
Item Default Setting
Code on
Page:
Cable Type Synapse Cable 1-2
Symbologies All Enabled 1-4
Transmit UPC-A Check Digit Enabled 1-8
Transmit UPC-E Check Digit Enabled 1-8
Convert UPC-E to UPC-A Disabled 1-8
EAN Zero Extend Disabled 1-9
Decode UPC / EAN Supplemental Disabled 1-9
UPC-A Preamble System Character 1-10
UPC-E Preamble System Character 1-10
UPC/EAN Security Level 0 1-11
CLSI Editing Disabled 1-12
NOTIS Editing Disabled 1-12
Codabar Decode Redundancy Disabled 1-12
Transmit Code 39 Check Digit Disabled 1-13
Buffer Code 39 Disabled 1-13
Code 39 Full ASCII Disabled 1-13
MSI Plessey Check Digit One 1-14
MSI Plessey 2 Check Digit Algorithm Mod 10 - Mod 10 1-14
Convert Interleaved 2 of 5 (14 digit)
to EAN 13
Disabled 1-15
Interleaved Code Length 14 1-15
Discrete 2 of 5 Code Length 12 1-15
Prefix/Suffix None 1-17
Data Transmission Format Data As Is 1-19
Transmit No-Read Message Disabled 1-20
Transmit Code ID Character Disabled 1-20
Transmit AIM ID Character Disabled 1-21
Audible Response Enabled 1-21
Power Mode Continuous 1-21
Laser On Timeout 3 Seconds 1-22
Hands-Free Stand Operation Timeout 60 minutes 1-23